I'm starting to tear down another VQ30 engine and will be recycling the aluminum.
So i have every part other then coilpacks. Anybody need anything?

 

Omg...where did you get all those max's? Junk yards?

How much did you pay for all that!!! Lmao

 

I need the Boost aka ram air sensor that sits on the top of the snorkel by the front of the engine, I have a 99. How much would it be shipped?

 

None of them came from junk yards. I got a few locally,a few from ebay,a few from members here,etc.I'm purchaing another one this week as well.They were all purchased in the last year and i spent around 15-20 grand

 

$15 shipped

 

I need this bolt that bolts to the tranny/shift linkeage.
it allows the shifter to be placed in neutral...without it it's hard to put the csr in gear unless you cut it off.

and a 96 passenger side fog light

pm me.

 

Sorry no manual trans parts or foglights.

 

any full set air bags? passenger + drivers ? tan/beige and to fit a 99 GXE

 

Sorry no bags that will fit a 99.

 

Anybody else?

 

what year is the maxima you're parting out right now? i dont suppose you have an 00-01?

 

How much for 6 coil packs ('95) shipped?

 

uhh, he said he doesn't have the coil packs already!

Joe - how much for the upper and lower intake manifolds? Also, I want to know what year max these parts are coming from

 

You wouldn't happen to have starter?? How much shipped to 01542??

thanks,
adam

 

95-98...........

 

$60 shipped for both They would be off a 96 engine

 

I don't thinks so but will double check. If i do $50 shipped

Yes i do have one.

 

You wouldn't by any chance have any working knock sensors. or o2 sensors. i also need tan vents if you have any.

 

I do have a few working knock sensors.They come with harnesses as well $40 shipped each.Possibly o2's.Which ones do you need? You need the center vents which house the clock and hazard/defrost switch?

 

I believe it's the drivers side in the back.

Yea.

 

Well theres three o2's total. Theres two in the y-pipe.One for the front bank one for the rear bank. Then there is one right after the catylatic converter.

 

I'll check again to make sure than I'll let you know

Thanks

 

I need an O2 sensor - fron and a crank position sensor?
How much to 60640?
Also, how many miles on them?
thanks

 

$40 shipped for both 116,000 miles

 

How much for Knock Sensor and Front Heated Oxygen Sensor (Right Bank) shipped to Montreal - Canada @ H4N2T2 ?

Also, those will work on a fed. 99 SE right?

 

Got a crankshaft pulley?

 

sent you a PM regarding a previous request (EVAP purge control valve) as well as also a knock sensor, thank you

 

Yes they will work on your 99. $70 shipped

 

Yes i do $30 shipped

 

Knock sensor? Any clue on condition? I am looking for one to test and see if my KS is faulty...thanks!

 

Yes i still have knock sensors. 100% working condition.$40 shipped

 

^^^^^^^^^^^^

 

How much wuold it be for the camshaft position sensor shiped to 93552?

 

The engine is completly disassembled.Anybody need anything?

 

got any 5spd trannys?

 

timing equipment/cover and anything related to the timing for the 3.5 swap

 

flywheel, more specifically the timing ring?

 

got a code 47 & code 34 i need Crankshaft Position sensor (ref) maxima 1995 GLE, knock sensor, starter,passenger side tie rod & all 4 bose speakers,
also need passenger side wheel bearing (with hub) for 2000 maxima GLE if u have
give me price on all this shipped
thanks

 

Any black interior pieces? Need C pillar, where seat belt goes through, drivers side

 

No manual trannys