considering parting out the motor i am building... i have put a lot of money into this and i want to go to school, so all my goodies need to go, including the car.

Anyway, about the heads, I had them professionally ported by my machinist that has recently retired, nothing but top notch work from him. I had him clean up the intake ports and do some bowl work. The intake split is knife edged. Exhaust ports were also cleaned up and polished.

While he was in there he installed the JWT valve springs and shims.

All of the lifters/cam buckets are the correct height for a cold lash of .010-.013" with the C2 cams.

Cams themselves are 261/261 duration, and have .456"/.456" (11.5824mm) lift
http://www.jimwolftechnology.com/cus...asp?PartID=461

also, the cams will have sprockets/phasers come with.

Price is $1900 OBO





Edit: i will also be selling the rest of the engine... ~1000 miles on it, ARP rod bolts, 04+ block, timing covers,upper/lower oil pans. swap on your topend and sensors and it will be ready to go. $750 picked up.

ttt

How much would this be shipped to Chicago, IL 60634?
I might contemplate the idea..... If I decide I will let you know....

$1900 shipped, let me know

k, but it wont be soon, unless miracles happen...lol