WTB : ONE wire from ecu harness
07-26-2009, 07:49 PM
#1
WTB : ONE wire from ecu harness
I just installed a 96 JWT ECU into my 97 max and I have to rewire a part of the ECU harness so I dont get a CEL code.
I need one wire pulled out of the harness and about 6 inches of wire to do what I need.
Can one of you please hook it up?
It looks similar to this:
I need one wire pulled out of the harness and about 6 inches of wire to do what I need.
Can one of you please hook it up?
It looks similar to this:
Last edited by sergofast; 07-27-2009 at 05:49 PM.
07-26-2009, 07:59 PM
#3
It can be anywire that you can get out. I have to provide ground to pin 112 and right now its a blank spot in the harness (my car is a 97 and I have a 96 ECU).
If you have access to harnesses and plugs I could also use the plug that goes into the 00vi....
If you have access to harnesses and plugs I could also use the plug that goes into the 00vi....
07-26-2009, 08:18 PM
#5
I need the female part of the pin and 6" of wire. Just that piece pulled out of a harness. Im going to take the pin and insert it in my harness so I can provide ground to that plug (this with the addition of swapping the 105 and 107 pins will eleminate the p0136 code that my ECU is giving)
Thread
Thread Starter
Forum
Replies
Last Post
Kingofmaximas24
5th Generation Classifieds (2000-2003)
1
11-12-2015 04:40 PM