Okay, not getting a ton of interest from the local crowd so its time to post it up here. A front end collision totalled my Max. All the interior and other miscellaneous stuff is intact. The motor and tranny (and all 5 speed related parts) are sold.

A few notes: The steering wheel is a 98 SE modified to fit the 95/96. The trunk is a 97+ painted Ruby Pearl. E-brake boot and armrest cover is from redline. The seats are from a G35, local sale only.
STEERING WHEEL AND AIRBAGS HAVE BEEN SOLD

 

 

Damn...sorry about the accident man.

What gauge is that above the AFC?

 

looks like an analog version of a A/F readout.....

 

Thanks. It is an innovative motorsports g4 air/fuel ratio gauge. The vafc is sold but the panel is still for sale.
60 shipped for the gauge.

 

Thanks. It is an innovative motorsports g4 air/fuel ratio gauge. The vafc is sold but the panel is still for sale.
60 shipped for the gauge.

 

Are the seats a direct fit on a maxima? And are the seat switches fully functional

 

okay, how much for all the injector clips, and belt tensioner shipped to 92870?

 

I don't have injector clips, I might have a belt tensioner I will check and get back to you.
Yes they are fully functional and they do bolt into the car.

 

How much for Shift trim and boot as well ebrake boot? Shipped to 76504. Thanks!

 

Any more pics on seats? if so you can email me them please at
israel.garcia.ri04@statefarm.com

How much for them?

 

how much for the armrest cover shipped to 19116?

 

Armrest boot is 18 shipped. My paypal is chillin014@aol.com
Shift trim and boot were sold with the 5 speed swap. The ebrake boot is 18 shipped. Ill send you pics of the seats later today, they are 300 local.

 

what did you hit man?? are you good yourself?

 

is it black? also led tail lights for sale?

 

Some Taco truck tried to cross the road in front of me without looking. I'm fine, the hit wasn't even that hard the bumper of the truck went over the bumper and ruined a lot.

the armrest cover is black, yes. The armrest itself is in good condition as well, I just liked the way the cover looked.

 

How much for the driver's side (LH) rear door shipped to 68832?

 

Hmm. Well do you want JUST the door stripped of all the panels and window/motor etc? How picky are you about the condition? I think it has a few small pits/door dings. UPS freight is showing 40 bucks for 50 pounds but that's a rough estimate. You're probably looking at just under 100 bucks total including shipping.

 

hey are those LED tails? how much and i was wondering about the auto climate control?

thanks

 

Guys....are you reading the original post? I said the tail lights are not for sale.

The auto climate control works but some of the led bulbs need to be replaced.

 

hey bro what part of houston are you at? i'm local and i'm interested in the seats, if you can, email me more pics gomezda85@yahoo.com

 

Southwest side, I emailed you.

 

What about the rear calipers, AND rotors are they sold and if not how much

 

They are still for sale. Shipping might cost a bit but I wont know for sure until I take them off the car. 40 + shipping. I estimated 30 pounds and that put shipping around 40 bucks, just as an estimate. It might fit in a flat rate box though, I'll figure it out for sure if you are committed.

 

Ok yea iam just wondering if it will be worth it to buy used or new brake parts. Iam really just looking for the calipers they seem to be the most expensive to replace.

 

I'd take 20 for the calipers plus shipping. I could do 40 shipped for just the calipers.

 

40 each or all together

 

together.

 

I don't need the motor or door card, etc. just the outer shell to be in decent shape, a few dings and chips is fine. I'll take it if you can do it for $100. I can send payment through paypal. My email is twilli@kdsi.net if you'd like to go that route.

 

Okay well tomorrow I will take the door off and get a better estimate and get back to you.

 

how much for the center vent shipped to new york city 10035

 

I doubt you'd want it, one of the little fins is missing. sorry.

 

Alright, I've stripped the door down to the shell. Most of the trim/gaskets, windows, door lock, panel etc is off. I left the exterior handle on there since I remember you had a thread asking about it. The weight is about 26 pounds and I think I'm going to be able to ship it fairly cheap with UPS. I can do it for 80 shipped.

 

Great, what is your paypal address so I can send money in short order?

Shipping address:

Todd Williams
403 N. 4th St
Doniphan, NE 68832

 

edit- Let me go ahead and get a legit quote from the UPS place tomorrow morning so there are no surprises.

I just typed in the dimensions etc and they are quoting me $118 to ship as the cheapest option. Somehow I got a cheaper price yesterday but I think it was false.

 

how much for the front calipers, lines, rotors and pads shipped to 90275?

 

oh yeah can you chop off that stock muffler and send it to me too? price plz.

 

I dont need to CHOP it off, i can just unbolt it...unless you prefer it chopped lol

Okay, the calipers,pads,rotors and lines- The lines are SS, and the rotors are slotted. Including shipping I'd like 100 bucks for the lot.

The muffler I'm going to have to ship separately and I need to check the weight on it but I'll take 30 bucks plus shipping. LMK!

 

Interested in the 5 spd shifter trim and both e brake and shift boot.

How much shipped to 40508?

 

5 speed shifter trim and boot went with the 5 speed swap.

the e-brake and boot i can do for 30 shipped.