I have an SSIM plus everything you need to swap it outside of Injectors(5th gen or any VQ35 injector+clips) My 3.0 went Kaboom and im moving on from this setup completely. 3.0 GUYS THIS SETUP IS NOT BOLT-ON, INTAKE PORTS MUST BE PORTED. you have been warned. Its not hard to do but if you are willing to attempt it I cannot make any guarantees on your work/porting, these parts worked just fine on my car.

I AM NOT PARTING OUT THE KIT.

What is included is:

SSIM(obviously)
Elbow adapted for pathy TB
Pathy TB
3.5 lower manifold
3.5 Rear valve cover.
3.5 Coil packs w/extended stems.
3.5 fuel rail with adapter for fuel line.
3.5 290cc stock injectors

Pics from when my car was still N/A:



The rear valve cover a hole in it created when i was pulling the motor. i repaired it in a semi ghetto fashion but it does not leak. I have the 3.5 cam bracket if somebody for any reason is building a 3.0. This setup should be able to move more air than the 00vi with ease. Although the 00vi does not have any choking issues this setup would be optimal for a high revving build. The normal 02VI been documented to give a 25-30whp gain over the USIM, you should see a little more than that uptop with the SSIM, you will lose some torque down low.

Edit: I have injectors, clips, and an AFPR so you do not need to buy anything extra i have all pieces to make it work. Just have to port the head.

$250+shipping. Money talks, no dibs, Not budging.

 

Pics from today. Setup is still on my 3.0 and the worlds messiest engine bay the whole kit will be off by the end of the week.








pics of the porting, my porting was ugly because this motor was only intended to be temporary and i didnt want to spend money on another manifold since i had an SSIM, but it did work.

 

Bump. Found my old injectors and clips so i will throw those in aswell.

 

Bump once more.

 

Stuff is still here, collecting dust.

 

still have this??

 

Still here everything is just collecting dust.