LuK clutch installed
04-09-2003, 03:36 AM
#1
LuK clutch installed
After considering the ACT Street and Exedy S1, on recommendation I went with the S1 LuK performance clutch and had it installed today. Organic disc, 40% increase over stock.
Can't tell you much about it yet, but initial comment is it feels freakin fantastic to have a decent clutch again. Very light pedal, sharp but really smooth engagement and no shudder/chatter at all. Stock Unisia clutch had about 3mm left before the rivets. F&R engine mounts were also replaced with new OEM's but the old ones weren't too bad (visually anyway).
Probably of more interest to Aussies that may read this it cost $800AUS all up. $500 for the clutch kit, $35 for flywheel machining and $275 to fit. Yeah, cheaper than a standard replacement from Nissan.
Purchased and installed through Adelaide Clutch Services in Torrensville, SA. Great place, performance orientated and stockists for LuK, Exedy, OSGiken, ACT etc.
Can't tell you much about it yet, but initial comment is it feels freakin fantastic to have a decent clutch again. Very light pedal, sharp but really smooth engagement and no shudder/chatter at all. Stock Unisia clutch had about 3mm left before the rivets. F&R engine mounts were also replaced with new OEM's but the old ones weren't too bad (visually anyway).
Probably of more interest to Aussies that may read this it cost $800AUS all up. $500 for the clutch kit, $35 for flywheel machining and $275 to fit. Yeah, cheaper than a standard replacement from Nissan.
Purchased and installed through Adelaide Clutch Services in Torrensville, SA. Great place, performance orientated and stockists for LuK, Exedy, OSGiken, ACT etc.
Thread
Thread Starter
Forum
Replies
Last Post
hez8813
5th Generation Maxima (2000-2003)
11
03-12-2020 12:06 AM
MaxLife17
8th Generation Maxima (2016-)
43
06-27-2019 01:37 PM