4th Generation Maxima (1995-1999) Visit the 4th Generation forum to ask specific questions or find out more about the 4th Generation Maxima.

Oh Oh...Help

Thread Tools
 
Search this Thread
 
Old Jun 26, 2003 | 08:02 PM
  #1  
C3nthusiast's Avatar
Thread Starter
Senior Member
iTrader: (3)
 
Joined: Jun 2002
Posts: 1,830
Oh Oh...Help

I drove my car all day today. This evening I started it and the idle went up to around 1500 to 2000 rpm and floated up and down. I revved it and it went down. I put it in drive and drove off. The 1st gear stuck and then jerked into 2nd and then 3rd. While driving about 30mph I would tap the accelerator and the engine would rev but the car would not pick up unless I really punched it. I thought that maybe I was low on fluid so I added a quart. I can still feel the jerk but it's not as bad as before. On the highway the car feels uneasy but may just be my imagination. I've had two bad O2 sensors and an EGRC code for 2 months. I don't see how that would affect the shifting. It just started today. But I ain't no mechanic. Any ideas?
Old Jun 26, 2003 | 08:22 PM
  #2  
97MaximaSE's Avatar
Senior Member
 
Joined: Aug 2000
Posts: 708
Re: Oh Oh...Help

Originally posted by C3nthusiast
I drove my car all day today. This evening I started it and the idle went up to around 1500 to 2000 rpm and floated up and down. I revved it and it went down. I put it in drive and drove off. The 1st gear stuck and then jerked into 2nd and then 3rd. While driving about 30mph I would tap the accelerator and the engine would rev but the car would not pick up unless I really punched it. I thought that maybe I was low on fluid so I added a quart. I can still feel the jerk but it's not as bad as before. On the highway the car feels uneasy but may just be my imagination. I've had two bad O2 sensors and an EGRC code for 2 months. I don't see how that would affect the shifting. It just started today. But I ain't no mechanic. Any ideas?

id say i hope this doesnt happen to my car anytime soon cause i cant afford a new tranny
Old Jun 26, 2003 | 09:55 PM
  #3  
luckee2bhere's Avatar
Senior Member
iTrader: (1)
 
Joined: Jan 2002
Posts: 1,993
From: San Diego, CA
i think you mean "uh-oh"

safe guess...your tranny is gone.
another safe guess. is you could do some serious damage with that thing in front of your rear license plate.
Old Jun 28, 2003 | 08:38 PM
  #4  
C3nthusiast's Avatar
Thread Starter
Senior Member
iTrader: (3)
 
Joined: Jun 2002
Posts: 1,830
Originally posted by luckee2bhere
i think you mean "uh-oh"

safe guess...your tranny is gone.
another safe guess. is you could do some serious damage with that thing in front of your rear license plate.
No...I mean "Oh Oh". I'm Filipino dude. Us asians can't pronounce "Uh" because it ends up sounding like "O".

I think I found out the problem. I adjusted my throttle cable too tight the day before. For some reason it affected how the tranny shifted. I noticed the hard shifts only happened 1)after I started the car 2) the car idled high after start. I loosened the cable and haven't had a prob since.
Old Jun 28, 2003 | 10:47 PM
  #5  
maximizd97's Avatar
Senior Member
 
Joined: Jun 2003
Posts: 317
From: IOWA
All is well again...maximas are so freakin reliable!




All times are GMT -7. The time now is 04:16 AM.