Anybody ever get the cel code ignition signal circuit...
#1
Anybody ever get the cel code ignition signal circuit...
After i changed my trani (5spd) and starter (96 to a 97) my car would take a little while to turn over. It would crank but not start so i took out my starter, took it apart, cleaned it and regreased it and then my car started fine for about two days then got worse and worse and now wont start. I also just changed my knock sensor, while it wasnt running. i dont understand it, i drove my into the carage fine and now it wont run. A tech at a Nissan dealership said i had a bad ground from my trani bell housing to engine block but that sounds a little --its aluminum anyways. Anywho, now i got cel code ignition signal circuit, i figure i should check the crankshaft positioning sensors, coils, etc.
Any help would be appreciated
Any help would be appreciated
Thread
Thread Starter
Forum
Replies
Last Post
jmlee44
4th Generation Maxima (1995-1999)
8
10-02-2022 02:13 PM
AaronL
5th Generation Maxima (2000-2003)
15
08-08-2020 10:31 AM