Harlan's switch setting
#1
Harlan's switch setting
Okay guys with Harlan's switch for their MEVI I need your help. I just did my MEVI install a few day ago and did the wiring of the Harlan's switch and routed all the vacuum lines today. I didn't have the instruction manual for the Harlan's switch since i bought the MEVI with the installation kit from somebody else. Can anybody tell me how to set the switch? How do you set the cylinder and RPM activation? What are the dipswitches and two buttons are for?
Don't flame cause i just finished reading the How to's and FAQ section and i didn't find anything helpful. If it's in there then my bad. I also tried getting the instruction direct from Harlan's site but the link is not working.
Thanks in advance guys!!!!
Eric
Don't flame cause i just finished reading the How to's and FAQ section and i didn't find anything helpful. If it's in there then my bad. I also tried getting the instruction direct from Harlan's site but the link is not working.
Thanks in advance guys!!!!
Eric
#2
I was looking for the same thing a couple weeks back. LOL Just look for the instructions on Harlan's website for the shift light. It's essentially an RPM switch with an LED attached. Those instructions worked for me.
Thread
Thread Starter
Forum
Replies
Last Post
jsmith24
5th Generation Maxima (2000-2003)
4
02-01-2016 12:35 AM
James92SE
1st-3rd Generations Classifieds (1981-1994)
4
10-08-2015 04:57 PM
viperboy
8th Generation Maxima (2016-)
4
09-27-2015 07:05 PM