Anyone here wire / install their own LED's under seats, and under the car? i think the underbody would be awesome because it would be harder to see than neons and give a great look! I was just wondering if someone has a writeup or any ideas.

ALSO cost, i know i'll need a sauting iron (30 bucks?) and the boards + leds + resisters should make the whole project take about 3 hours, and about 100 bucks.

right?

 

why led's under the seats..i installed neons inder my seats. They make L.E.D kit to goo under cars already

 

They make neons for every square inch of the car now.

 

so true

 

i don't want neons, i hate the look of the bulbs and i could make this ALOT CHEAPER, also i could make it so that it looked brighter than neons. I just wanted to know if someone had looked into this. If not then i'll write my own DIY.

 

Order confirmation:
--------------------------------------------------------------------------------

register how-to-wire-leds.info 1 year(s)


So in a few days check out how-to-wire-leds.info for the write up!

 

Interesting.... I'm planning on doing it, but I need a 12V power source from arm rest.
Some mention the cigrette light, I need to do a bit more planning first.

Let me know how it goes...

 

ok, i plan on wireing my under seats from the power seats, my motor is f'ed so it should do ok there, i may grab the power from the bat for the under body.

 

I think the power from the powered seats are constant so your LED's would be on 24/7. You would need a switch to control the LED's probably. Which wire are you goign to tap into?