i am trying to do the dr mod, and i am curios of the wireing. i looked at the how to, adn for some reason it's not clicking on how to do it, if someone who has done it has an actual pic of how his is wired up, i would like to see it please.

 

Look for Jime's write up in the Nitrous forum.

 

I believe it is in the FAQ's too.

 

here ya go i just took a picture of it for ya... basically cut one wire and have both ends continue to a switch where you can either make or break the circuit i ran mine through the firewall with wireloom if you can see that worked out awsome no wire mess just perfect. i used the white wire and with the blue wire connected to the resistor side of the white wire and the clear side connected to the other end of the wire that you cut and run those two wires to a 2 prong switch thats either off or on always keep it on so it completes the circuit and then when you want it to work flip it the other way (to off) and it will work but NEVER EVER use it when not going at wide open throttle! very important, and always turn it off after youre in the gear that your gonna stop shifting at otherwise when you let off your gonna have a nice little suprise as you hear the tranny shifting as hard as youve ever heard it and felt like it came out the bottom of your car (trust me i know...) thats all i think there is to know and goodluck with the rest of the install update me when your done and let me know how it works out for you. -ryan

 

ryan thanks , pic makes a lot more sense to me now, let you know here in a few minutes what i think about it. shouldn't take me too long, thanks again

 

no problem man