Exhaust tip sizing
09-22-2004, 08:03 AM
#1
Senior Member
Thread Starter
Join Date: Sep 2004
Posts: 192
Exhaust tip sizing
I want to keep my stock exhaust, but I dented the tip that is currently on it. So I'm looking for a new one.
Is there a way to get a new tip installed...Without the screw that holds it in? can you get it welded on? and is there a way to not have the real inner tube visible? I just want the exhaust to look like a real aftermarket one, w/o the ugly rusting tube inside..
also, what size would i get for a 1996 SE?
Is there a way to get a new tip installed...Without the screw that holds it in? can you get it welded on? and is there a way to not have the real inner tube visible? I just want the exhaust to look like a real aftermarket one, w/o the ugly rusting tube inside..
also, what size would i get for a 1996 SE?
09-22-2004, 08:22 AM
#2
Buy a tip you like with a neck that will just slide over your stock pipe, have a muffler shop cut your pipe back far enough to leave a weld point for your new tip, that's probably the best you'll get without changing the muffler. Hope this helps
.Here kitty kitty . . .
Thread
Thread Starter
Forum
Replies
Last Post
CAN-Toronto FS: Basement cleaning
knight_yyz
5th Generation Classifieds (2000-2003)
12
11-01-2015 01:34 PM