Warpspeed cat back exhaust

Subscribe
Jun 20, 2005 | 10:05 AM
  #1  
Anybody have a catback from warpspeed with the quiet clone muffler? If so how was the fit and finish, and how was the fitment.
Reply
Jun 20, 2005 | 10:10 AM
  #2  
great
Reply
Jun 20, 2005 | 11:00 AM
  #3  
i have it and really like it but fitment was bad. the pipe going into muffler hangs very low and scrapes when going over bumps and when i have people in back seat. other than fitment i am pretty satisfied with it. it is quiet at idle but at wide open throttle it has a nice growl. not ricey at all. I am eventually going to go to a muffler shop and get another hanger welded on or something.
Reply
Jun 20, 2005 | 11:17 AM
  #4  
mine used to hang low, but i fixed it buy loosening the bolts to the cat, putting a jack under the b pipe, raising it to where i wanted it and tightening the bolts and its stayed up.
Reply
Jun 20, 2005 | 12:35 PM
  #5  
I Have their b pipe and y pipe with a magnaflow muffler from them. The Y pipe is awesome fitment and craftsmanship but the b-pipe sucked when it came to fitment. I had to take it to a muffler shop and have it bent and they welded the conections on instead of the clamps you get from warpspeed. If i had to do it all over again i would buy a full catback exhaust. The product is great tho ive had it on since september and it hasnt rusted it still looks brand new. the only issue i had was fitment with the b-pipe. IT was hitting under the body of the car and scraping the pavement when ever i went over speed bumps but that was because the car is a lil too low. (s-techs)
Reply
Jun 20, 2005 | 04:31 PM
  #6  
As far as the sound is it obnoxious like the Greddy SP I have right now or is it a good bit quieter?
Reply
Subscribe