The under shield, plastic that keeps rocks from hitting from underneath the car. Plastic, mines come undone do to rust and broken clips. I got duct tape on it now and it looks like crap.

Proph

 

Splash guard..

. Mine always gets caught in awkward positions under the car and is a PITA to correct.

 

you can go to autozone or your local auto store and buy those plastic rivets or whatever they are....bought a pack of 6 for like $3 I think and redrilled some new holes and just tucked the front part under the bumper

 

I just f'd mine up the other day. I gotta buy new plastic rivets. But I also snapped one of the regular bolts inside. Gotta figure out a way to get the bolt out...any ideas?

 

just take them off

 

mines off, I took it off when i did my *99* front end conversion.

 

PLUUUUUUUSSSSSS 1

 

not a very good idea. When i took mine off, my AC pulley bearing went bad shortly afterwards. Its there for a reason.

 

could also buy just black zip ties and just zip tie them up or something....whatever works

 

Mine have beed off for about 2 years now when I did my clutch. No issues at all. But sure, it could let some water into the engine bay. I kept the side ones on, they seem more important. Especially for the pulleys and belts.

 

The holes that the screws go in tore so zip tieing them is not an option. I really dont want to take them off with all the rock drive ways and highways i go down.

 

boneyard is your friend

 

cut/drill holes next to the original holes and ziptie it from there? think outside the box a little... i have also seen new ones available. coutesynissan, perhaps? check a few of those sites.