Questions about blower motor resistor..

Reply Subscribe

Thread Tools

Search this Thread

09-18-2006 | 10:18 AM

lophix

Thread Starter

Senior Member

iTrader: (3)

Joined: Apr 2002

Posts: 1,716

Questions about blower motor resistor..

Does the whole blower motor have to be taken out and the board resoldered as stated in the faq or is there something else that needs to be done?

09-18-2006 | 03:01 PM

Maxima_Joe

4th Gen Parts King

iTrader: (384)

Joined: May 2002

Posts: 7,775

From: Moorhead, MN

Only the board needs to come out. There is two screws holding it on.

09-18-2006 | 06:54 PM

nsnrider

Supporting Maxima.org Member

iTrader: (59)

Joined: Jun 2006

Posts: 2,785

From: Chicopee, MA

yeah, real easy, just look under your dash on passanger side on the bottom of the a/c unit, and in the middle towards the back you'll see a plug with two screws on the side of it. gl

09-18-2006 | 07:11 PM

lophix

Thread Starter

Senior Member

iTrader: (3)

Joined: Apr 2002

Posts: 1,716

Scrape off the old solder and put a fresh layer on each spot?

09-18-2006 | 08:29 PM

lophix

Thread Starter

Senior Member

iTrader: (3)

Joined: Apr 2002

Posts: 1,716

Update:
I scraped off the old solder points/dots and put fresh solder on. The soldering was kinda rough but it worked. Better than $53 that the dealers here were asking.
:-)