Get the exact one from partsexpress.com, check on hidplanet forums if the capacitor has to be the exact farad, definitely some rocket scientists on there.

 

Well I redid all the harness. It has all new diodes and new capacitor and resistor. Yet I have no hi beams.

If I unplug the relays and then turn on the high beams and plug in 1 relay at a time. I get no clicking sound.

If I turn on the low beams and plug in 1 relay at a time. I get a click from 1 relay socket. But I tried both relays in the same socket and they both click so I know it isnt a relay issue. It either the wiring harness or there a problem with the circuit of the projectors. I checked every wire on the harness and there was no problems. No broken wires or loose wires.

I have wasted so much time messing with this harness. I have used like 2 rolls of tape and I have yet to get them to work I have taken the harness out numerous times. Im sick of it. Now I gotta go out tomorrow and finish putting it back into the car unless someone has an idea? This sucks!

What do you guys think? Id really like to have my hi beams.

 

Whoaaa

Where the hell did YOU come from?

 

Alright guys. I went out and tested the solenoids today and both shields did flip.

I started on the passenger side since it was easiest to unhook so I checked the passenger light first and the shield did flip so that was good. I then took the 2 wires that were connected to the passenger side that ran across to the driver side and hooked them up and the shield did flip. It actually turned my lights on on both sides even though I didnt have the 2 wires hooked up on the passenger side :/

So where do you think my problem lies guys? Id like to solve this.