Hey, guys, I disassembled the harness of my headlights a long time ago and now whenever I put it back together I do not get a full strength light output(kind of weak) and I get a slight high beam light on the dash. I would like to see either a picture or just if someone could give me an order in which the wires go in the plug(black, blue and green). Thank you.

 

I just fixed this recently myself. There's only 3 wires just swap them around until you get the desired results. I think I swapped the ground and high beam wires on mine, but your results may vary.

 

With the flat part of the connector towards the sky and looking at the rear side where the wires go in, the terminals are numbered 1-2-3 left to right.

Drivers side:
1 - Yellow
2 - Green w/ Yellow Strip
3 - Black

Passenger side:
1 - Light Green w/ Black strip
2 - Blue w/ Black strip
3 - Black

 

Thank you, guys!

 

that helped me 2