Whats up org.

I have a hole in my flex pipe....what are my replacement options...its a 95 auto....and im on a low budget!!!

 

Sounds as if you have a misfire. Check for stored error codes.
Could be coils or injectors.

 

a

 

that was an answer to another question i has........ thanks

 

anyone?

 

Not sure how mechanically inclined you are and what you are looking for in your exhaust performance overall, but you can either replace the entire y-pipe or get some quotes from an exhaust shop for a new flex pipe section. They can hack the broken flex pipe portion off and weld a new one on... I've done this in a pinch on my previous Max for convenience and I didn't want to dump any more money into it... Depending on the shop and area, prices are about $125 for everything...

 

i was thinking about doing that flex pipe change..but idk...what is other parts of the get holes...then i would need a whole new y pipe....are there any cheap options i can go with...i dont want reacing noise......i saw this on ebay...what you guys think...
http://cgi.ebay.com/ebaymotors/1995-...Q5fAccessories

i would just use the y-pipe piece...not headers..

 

check summit, Jegs, or vibrant!

 

be careful i think its easier to fab full headers y pipe than it is to fab just the y. that said many "cheap" setups are that way as the require the use of their headers it saves them R&D costs they may not just bolt up to your manifold. in fact i would like to see it anyone has had luck just using the ypipe with these cheap options.