If you can, could you take a macro picture of your throttle body set screw, from an above angle, looking at the back of the screw where it touches a brass arm.


I'm trying to figure out how much the TB is opened by this and if all we're factory set to the same spot. Unfortunately I messed with mine through the 00vi process and I need to find its sweet spot.




Thanks!

 

SORRY NO PICTURE but the throttle plate should be open slightly like a hairline or no vroom vroom so back it all the way off and stick a dime in between thw screw and the throttle linkage then remove the dime until the desired idle is achieved tighten the nut and enjoy your max