rear valve cover: where to put sealant?
#1
rear valve cover: where to put sealant?
so far i put some sealant in the groove of the valve cover thin bead all around to hold the gasket in.
should i also apply a thin bead across the mating surface on the head? or only around the corner where it is more prone to leak? how did you guys do it?
shout out to ATTappman...great how to.
should i also apply a thin bead across the mating surface on the head? or only around the corner where it is more prone to leak? how did you guys do it?
shout out to ATTappman...great how to.
#2
#3
^ thanks for the great pic. i still haven't gotten everything back together...by the time i get back from work its dark and i really can't do much. hopefully ill have everything back together tomorrow and no leaks!
also suppose there was a part of a leaf just hanging out on the head and i sealed everything up would that destroy the engine? i only say because i almost didn't see this thing as i was putting everything back together it was right in the corner too, i did pull it out though. lol
also suppose there was a part of a leaf just hanging out on the head and i sealed everything up would that destroy the engine? i only say because i almost didn't see this thing as i was putting everything back together it was right in the corner too, i did pull it out though. lol
Last edited by eFLO; 11-07-2010 at 03:32 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Matt93SE
1st-3rd Generations Classifieds (1981-1994)
15
04-08-2018 09:23 AM
Huttig2009
5th Generation Classifieds (2000-2003)
8
09-25-2015 03:31 PM
MaximaDrvr
7th Generation Maxima (2009-2015)
16
08-19-2015 08:20 PM