Indiglo gauge install...
#1
Indiglo gauge install...
Yes, I did take some time to search this topic. Anyway, I trying to figure out the best/easiest place to run my positive and negative wires for my indiglo gauges? Any pics would be greatly appreciated too...Thanks.
#5
i have the indiglo, be careful with the frickin needles. real easy to break and they stick sometimes. my water temp gauge sticks all the time, i just tap the front of the cluster and it unsticks.
#8
I would wire it into the cluster. The 4th gen is easy, you can just solder to the + and - wires on the rear of the cluster, they're well marked.
You will need to use flux to get the coating off the section you're soldering on the board, and be careful not to overheat the plastic layer.
You will need to use flux to get the coating off the section you're soldering on the board, and be careful not to overheat the plastic layer.
Thread
Thread Starter
Forum
Replies
Last Post
220k+ A32
5th Generation Maxima (2000-2003)
18
09-22-2015 11:39 AM
RWCreative
4th Generation Maxima (1995-1999)
9
09-21-2015 11:01 AM