starting problem plz helppp
#1
starting problem plz helppp
What's going on people I have a 4th gen maxima 5speed and my starting problem is weird ithe car starts no problem first shot after I turn it off and start it back up it doesn't wanna start it just keeps cranking I just recently changed the cam sensor so I know that's not the issue could it be a fuel pump or may be a ignition switch. And when it doesn't start I can kick start it no problem by pushing it backwards and popping the clutch no problem any feed back would be great thanks
#3
Maybe your starter isn't cranking the engine fast enough. The starter has a planetary gearset in it that loses its lubrication and binds, slowing the cranking. The warm/hot engine may make the binding worse than when the starter is cool.
#4
Cmon fumes mang, u know the drill with clean mating surfaces and grounding issues.
check camsensor.
Add a ground wire from negative battery terminal to tranny housing.
Dont forget to clean MAF and TB.
check camsensor.
Add a ground wire from negative battery terminal to tranny housing.
Dont forget to clean MAF and TB.
#6
+1 Starter is the most likely cause of your starting problem. Mine tooks 2-3 months of difficult starts before it died completely. It would crank but not fast enough to start the engine.
#7
Mine had an issue where I'd turn the key and nothing. Then I'd turn it again and when cold it would crank forever until I pumped the gas to get it going.
I changed the ignition switch and it solved both problems.
I changed the ignition switch and it solved both problems.
Thread
Thread Starter
Forum
Replies
Last Post
sctludwig
3rd Generation Maxima (1989-1994)
8
09-01-2022 01:32 PM
trungg86
4th Generation Maxima (1995-1999)
7
09-04-2015 04:58 AM