Copious

Any idea which pin(s) and what the test should reveal, I read somewhere (can't find it now) it should test at 370-470 ohms only, but which pins are being probed, there are three? From a 97 Infiniti I30 lower part of engine, not the one near pulleys, that is a two bolt - to lessen the front - back - left - right confusion.

D.Stillwell

What is that thing, cam or crank? and what year is the car? I can link you to FSM but need the year.

Copious

It is a crank position sensor, but your question concerns me if you were going to answer this question!

DennisMik

iTrader: (2)

The service manual does not give a resistance reading test. It says to unbolt the sensor from the car and measure for 5 volts between the white and black wires when moving a screwdriver across the tip.

See page 346.

http://boredmder.com/FSMs/Nissan/Maxima/1998/EC.pdf

D.Stillwell

Relax. small pic viewed on my phone looks like it could be cam as well, didn't realize you wrote CPS in topic I though it was CMP and I may have been stoned.

anyway Dennis already provided the proper infos