Adding Digital temp gauge
I have one.
Innovate had a dual gauge that shows voltage and water temp so I installed that with my AFR in a dual gauge A-pillar pod purchased from a part out.
I went to Z1 online and ordered an adapter to put on the hose that held the sensor.
I believe most just use an OEM spot though, but I wanted to leave it alone.
Innovate had a dual gauge that shows voltage and water temp so I installed that with my AFR in a dual gauge A-pillar pod purchased from a part out.
I went to Z1 online and ordered an adapter to put on the hose that held the sensor.
I believe most just use an OEM spot though, but I wanted to leave it alone.
I sort of had the same on my 5.5 gen. Used the ECU signal wire from the VSS, ECT, MAF, RPM and IAT (2 speed signals, and three 0-5v inputs). Tapped the ECU wires, and used the FSM for voltage/hertz to whatever unit conversion curve and it was actually quite swell. Doing just the ECT should be easy, as FJF said.
Thread
Thread Starter
Forum
Replies
Last Post
BPuff57
Advanced Suspension, Chassis, and Braking
33
Apr 16, 2020 05:15 AM