All parts are in Denver, Colorado. Some can be shipped, some cannot.

My 99 Maxima finally gave out this year and I scrapped it. I have a few parts that have been sitting in storage for a while now. PM me if interested in any of them.

Manual Transmission w/ Quaife ATB differential. It will need rebuilt as I sheered the axle in a race and it bent the c-clip inside the trans. My mechanic welded it back together nicely so I could get around until I got my spare transmission rebuilt and put back in. It has been sitting in storage ever since. This is a local only bit since it is too heavy to be shipped. Depending on the offer I might be willing to drive and meet you somewhere if it's within 2-3 hours of my house.



OEM Grade catalytic converter. My car wouldn't pass emissions with the cattman headers, ypipe and cat on, so I had to swap this on to pass last time. Used for two days and then removed. Still comes with new gaskets. Would be willing to ship. (wish I could've grabbed the cattman header setup off the car before I scrapped it, but it was stranded in my work parkinglot piddling fluids like an old GMC Blazer.


2.5" stainless catback exhaust. Never could install it since the previous owner of my car had personally and poorly welded a catback and in the process he removed the small section between the cat and catback that the O2 bung went in. This catback didn't come with that section and I never got around to having a custom 2.5" piece made. Local only, not worth shipping.




Custom fiberglass boxes for the wheel wells. I had these made for 10" alpine type-r subs. I may still have two 10" alpine type-r's left, but I'd have to check. These are designed to fire the bass up at the roof so it reverberates throughout the car. Could possibly ship depending on the offer.




There are various other things.
A stock black trunk that is pretty scratched up from floating in storage for years. (free if anyone wants to pick it up)
A carbon fiber hood which never got installed. I drilled holes for locking hood pins only to realize I hadn't calculated for the angle of the hood vs the angle of the radiator support. I was always going to get around to fabricating pieces to make the fitment possible, but I never got around to it.


I let most of my parts go to the scrap yard with the car since it took a crap 35 minutes from home. Looks like the rest got taken down to Florida, so I will have to wait to list it til I get it back.

I also have a lot of offroad parts for a D21 Nissan Hardbody and they should also be compatable with a 2000-2001 Frontier. Some of them are not even used.
Bed Rails (never used, been in storage)
Dual Rail light bar
Tire Gate with an unused 35" tire (though it's been sitting in the sun now for a couple years)
ARB Bash Guard w/ a 9000lb Warn winch already installed (never used, but been sitting outside for a couple years)