***MEASUREMENTS FOR TYPE II SPOILER*** please read & reply
Thread Starter
Senior Member
Joined: Oct 2000
Posts: 5,808
My rep over at Stillen gave me measurements for the spoiler. They are as follows:
Looking at the stock spoiler from rear of car, look at the two center two pedistals (below LED light) now measure from the center of each one I got 24 1/4 inches across(center-center)Almost a direct fit!!
As for the end pedistals, near the edges of the trunk, they will NOT be bolted down to the car, Stillen provides us with a rubber gasket and double stick tape to hold them down. Also a hole for the LED power wire. Should be plenty, unless you yank on your spoiler everyday! The LED included is 10 inches wide.
My Measurments of STOCK NISSAN SPOILER:
1) from center to center of pedistals
24.25 inches
Stillen Measurements of TYPE II SPOILER:
2) from center to center of pedistals
24.5 inches
In my homest opinion its gonna be very close!!
He told me that he gave a 1/4" or so of leeway for the wing to fit with the OEM holes. Stillen didnt have a Maxima on their lot to try and fit up the Type II spoiler to it. They also told me that "THEY CANNOT GAURANTEE FITTMENT TO THE OEM HOLES" So I think I will be the guine pig for all of us and see how it fits on my car. I will order one Monday and fill you guys in as soon as i get it on my car, probably by the end of next week sometime. Hope she fits..... if it does fit i will post and give you guys the Extenstion for the Group deal over at Stillen for when you order.
**PLEASE REPLY TO THIS** I NEED DEFINITE BUYERS!!!!!!
ATLEAST min of 10
Anthony
NY96maxse
Looking at the stock spoiler from rear of car, look at the two center two pedistals (below LED light) now measure from the center of each one I got 24 1/4 inches across(center-center)Almost a direct fit!!
As for the end pedistals, near the edges of the trunk, they will NOT be bolted down to the car, Stillen provides us with a rubber gasket and double stick tape to hold them down. Also a hole for the LED power wire. Should be plenty, unless you yank on your spoiler everyday! The LED included is 10 inches wide.
My Measurments of STOCK NISSAN SPOILER:
1) from center to center of pedistals
24.25 inches
Stillen Measurements of TYPE II SPOILER:
2) from center to center of pedistals
24.5 inches
In my homest opinion its gonna be very close!!
He told me that he gave a 1/4" or so of leeway for the wing to fit with the OEM holes. Stillen didnt have a Maxima on their lot to try and fit up the Type II spoiler to it. They also told me that "THEY CANNOT GAURANTEE FITTMENT TO THE OEM HOLES" So I think I will be the guine pig for all of us and see how it fits on my car. I will order one Monday and fill you guys in as soon as i get it on my car, probably by the end of next week sometime. Hope she fits..... if it does fit i will post and give you guys the Extenstion for the Group deal over at Stillen for when you order.
**PLEASE REPLY TO THIS** I NEED DEFINITE BUYERS!!!!!!
ATLEAST min of 10
Anthony
NY96maxse
Thread
Thread Starter
Forum
Replies
Last Post
trsandrew
7th Generation Maxima (2009-2015)
17
Apr 8, 2016 06:45 PM
trsandrew
Group Deals / Sponsors Forum
2
Oct 25, 2015 02:47 PM