Well after my failed install, Im taking it off so I can plan a couple of other things and put a 3.125" on there as well. And also my cousin who will move only 1mile from me has a Garage in his new Townhouse, I will do the install there.

Now my question is, since I put the oil drain back plate, I will put a rubber cap with a hose clamp on top of it.

But what about the Oil Feed line? Am I going to have to remove it entirely? Or have you people found a "nipple" plug for the other end (where it goes into the s/c nipple) of the braided oil line? If I can find a nipple plug, that would be best, cause I dont want to take the line off since I will have to do work on the car again in the apartment parking lot which I have been for-warned on.

Any suggestions on that braided line would help me.

Dixit

 

Damn, if any of the moderators see this, can you move it to the General Forum, I meant to put it there.

 

Go to Home Depot and buy a bolt.