Yoogie

Sorry for posting this question guys, but I am installing my Tein springs and KYB GR-2s. I cannot figure out how to release the rear clips holding the side trunk liner panels in. I tried the search function, but I am not allowed....If somebody could either post how to remove the clips or e-mail me, I would greatly appreciate it. I am taking pictures of my install, so I will have some good before/after pics of this combo.

Todd

Bulldawg

iTrader: (1)

there should be a little spot on the clip to slide a flathead in, then pry outwards and it should just pop out. I had some trouble getting a few of mine out but that is all you should have to do.

spta97

iTrader: (1)

And the others unscrew I beleive. When I Peal & Sealed (ghetto Dynomat) my trunk I found it helpful to mark the holes with a felt tip marker. That way, when I put it back together I knew what when where (ie: "X" for clip, "O" for screw, etc.).

Please post experiance with your strut/shock combo. I'm close to getting the same.