Ok, I know this is probably a wornout thread, but its a last ditch effort for more info. Im going to attempt to install my PIAA foglight bulbs in the morning, and Ive heard some horror stories. I was wondering if anyone has any diagrams, or any other helpful info that will make it run more smoothly... Any info is cool. Thanks.

 

Have fun....

J/K... here's some help. Undo all the rivet thingies (black plastic stuff) from the outer edge of the car. Keep going until you get to the middle of the wheel. Next pull/push the black fender away so you can put your hand and see the fogs from the inside. Undo 1 screw and push. <b>CATCH THE LAMP<b> because it's going to fly out. Undo the bulb and follow the instructions in reverse to reinstall. Hopefully this helps! Good luck!

 

man dont' lie. you simply grip the fogs from the ouside adn unscrew it counter clockwise like a lighbulb in ur house.. j/p do as kev said but dont' touch the bulbs with your bare hands. the natural oil from it will cause the bulb to burst when it gets hot. if u do touch it wipe the bulb clean using rubbing alchi..

 

Doh! Forgot to close the bold...

 

i was trying to make it look like part of my sig. does that just happen since i quoted you? and u had bold at the end??

 

I forgot to close the bold, so when you quoted me it stuck with you. Once you finished the message, it automatically closed the bold because it's a new cell. Don't mind me, just babbling as usual.