Has Anyone Rewired 2k2 High beams to work independent?
#1
Has Anyone Rewired 2k2 High beams to work independent?
Wondering if anyone with a 2k2/2k3 has rewired thier High beams to work independntly. Bascially, i want to flash my high beams without my HID's comming on...
#4
Cannot be done, because the the relay for the Hi beams goes is the same relay for the HIDs. What would happen is if you wired it to use 4 relays instead of the 2 that are there, every time you hit the high beams the HIDs would turn off (this is what you want, but at night you will lose the HIDs if they are on, and there will not be enough illuniation). It would have to be re-designed to use 4-6 relays and alot of other things. Basically, making a separate circuit for each of the 2.
#5
http://www.vqpower.com/v2/modules.ph...article&sid=47
"2002 HID conversion (HID stay on when the high beams are on)"
?????
"2002 HID conversion (HID stay on when the high beams are on)"
?????
#6
E55amg2. I was thinking the same thing about the relays. im at work (best buy) with my car in teh shop playing and flickering my hi beams, testign teh relays. I think it'll be much easier to just, make an independent relay bank setup. to click the hi-beams on and off, after i find the wire that comes from the headlight stalk. Just a pain in the *** to do. Id love to be able to hi-beam people without my HID's fickering.
#9
Originally Posted by BigDogJonx
Thats amazing, all this time I thought my wiring setup had this problem and there Nissan goes and does the same dumbazz thing on the 2k2's. But defientely no way of fixing it.
Dixit
Dixit
stupid POS>
#11
Originally Posted by E55AMG2
dude, just re aim you HID's up a little and you can hit them with both the HID and the Hi beams...
#14
just honk man... my hid stay on with my high beams, but when i flash both flash (when hid's are off).. my high beams are almost independent of the hid... u'll hafta use a relay man and rewire the light switches. they made it that way so people wouldn't leave their high beams on when they turn the car off with the lights still being one (when stuck in high beam position)
#15
When I did my 2k2 light conversion, if you pulled the light stalk, they would flash the Highs only.. whereas pushing them would be both.
I only used a relay on the highs.. Ground was to the body and relay powered of the driver side high beam (+)
I only used a relay on the highs.. Ground was to the body and relay powered of the driver side high beam (+)
Thread
Thread Starter
Forum
Replies
Last Post
jerrod99_se-l
4th Generation Classifieds (1995-1999)
2
08-27-2015 08:27 PM
MaximaDrvr
7th Generation Maxima (2009-2015)
16
08-19-2015 08:20 PM
YourLocalAsian
6th Generation Maxima (2004-2008)
3
08-17-2015 02:33 PM