Hey I'm going to do a full exhaust including headers to the back. I have heard that you need to move the O2 sensors as in rewire them to reach were they need to go. I have also heard about a O2 simulator. I was wondering what is the best way to go? If you say simulatior how much and do you have link of where to buy them.


Thanks

 

If you are going to run your cat, then you can extend the wires and it will work fine. However you have to weld in a couple of bungs after the cat to screw them into.

The simulator is much faster and easier and requires no welding etc. They can be purchased for $25 for a dual output at http://www.o2simulator.com. Also you do have to have the o2 sensors electrically connected for the o2 sim to work.

 

Damn... all you people with so much time and money for headers... jk... anyways, as far as I know, the O2 sensors will be extended to that they are connected to the midpipe just after the main cat.... I'd post a pic for ya, cuz I've seen several, but don't have time to look for em right now. I'm sure someone else will have one though. As for the O2 simulators, I don't know enough about em to say anything. For starters, try asking BlackbirdVQ (I think that's how ya spell it) or Ice2K1; they've given me great advice and info in the past....