HTownMaxSE

Ok well driving down the freeway something flies and hits my headlight pretty hard. Now i notice it aims about 1 inch lower than the other one.

I think it loosened something because, I can wiggle the headlight back to the original position and then it falls back to the lower 1 inch position. It wiggles back and forth about a cm.

I was wondering what all is exactly holding the headlight still and in position.

crispykid717

iTrader: (7)

2 bolts on top of the headlight and the metal pin that is on the "outside" side of the light hold it in place. Is that pin bent?

HTownMaxSE

where is this pin exactly located?

Lontar1

iTrader: (5)

you will have to take the housing out to see the pin.... is from the front of the car on the side of the housing.. it goes "inside" with the fender...

fall97

I have condensation on the inside of my headlights. Sorry I dont have pics, but does anyone know how I can handle the problem?

TXT-1

iTrader: (1)

How about you start by not hijacking someon's thread?

TwoToneMax

There is also a plastic guide underneath the light that attaches to the radiator support (square roughly 1 1/2 by 1 1/2 ) you could have knocked that off. If it's the drivers side it's the corner closest to the grille on the bottom. Hope this helps.

Lontar1

iTrader: (5)

Hijacking is wrong in the forum and can get you banned.. but I will answer this one.. just put some silicone around it and you are good to go..

HTownMaxSE

thanks people. I'll take a look at it tomorrow. I think its those pins that keep it in place after you take out the two bolts on top.

Its the passenger side.