getting BA9s to work correctly in map lights.. do i need to reverse wires?
#1
getting BA9s to work correctly in map lights.. do i need to reverse wires?
i picked up some 5led BA9s for my map lights, but i cant seem to get them to work,..i remember reading somewhere that wires need to be reversed because of the polarity,..is this all i need to do? --just pull the top off and splice into the wires and run them to the oppisite place it was going to? any help is appreciated..
Edit : found the single post,... http://forums.maxima.org/4503814-post3.html any help?? i dont want to go hackin up wires if it wont work..
Edit : found the single post,... http://forums.maxima.org/4503814-post3.html any help?? i dont want to go hackin up wires if it wont work..
Last edited by mist max2000; 11-28-2008 at 11:16 AM.
Thread
Thread Starter
Forum
Replies
Last Post
jerrod99_se-l
4th Generation Classifieds (1995-1999)
2
08-27-2015 08:27 PM
kirkhilles
5th Generation Maxima (2000-2003)
2
08-08-2015 10:53 AM
bassmann
4th Generation Maxima (1995-1999)
1
08-03-2015 07:53 PM