Installed new ignition tumbler... car wont start! Help?
#1
Installed new ignition tumbler... car wont start! Help?
Okay so I just installed a new ignition tumbler... now the car wont start. I'm sure this is something to do with the immobilizer but can't figure it out. The new tumbler (used) came with a little black box that mounts on it which I assume has something to do with the immobilizer.
We tried using the old black box and the new one and it wont work either way... now we put the original pieces back in and the car starts fine.
With the new tumbler the car would turn over but not start...
Does anybody know if there is a procedure to learn the new key without taking it to the dealer? My Haynes manual basically just says it has to go to the dealer.
We tried using the old black box and the new one and it wont work either way... now we put the original pieces back in and the car starts fine.
With the new tumbler the car would turn over but not start...
Does anybody know if there is a procedure to learn the new key without taking it to the dealer? My Haynes manual basically just says it has to go to the dealer.
Thread
Thread Starter
Forum
Replies
Last Post
Lakersallday24
6th Generation Maxima (2004-2008)
10
06-16-2019 01:35 AM
Maxboy23
5th Generation Maxima (2000-2003)
7
08-11-2015 11:59 AM
Greenmaxspeed
4th Generation Classifieds (1995-1999)
0
08-08-2015 12:39 PM
kirkhilles
5th Generation Maxima (2000-2003)
2
08-08-2015 10:53 AM