Intake pipe questions
#2
This is weird, but I happen to have a MAF housing right here on my desk.
The inside diameter appears to be 2 and 3/4". The outside diameter seems to be 3 and 1/8". That's the TB side of the housing. The screen side is awkward to measure because of the flange.
The inside diameter appears to be 2 and 3/4". The outside diameter seems to be 3 and 1/8". That's the TB side of the housing. The screen side is awkward to measure because of the flange.
#4
TB = 75mm
Need to measure those things from the rear.=, which gives a true value.
Even if all the ID's aren't the same, a 3" MAF housing still massively increases throttle response given the right software configuration.
Need to measure those things from the rear.=, which gives a true value.
Even if all the ID's aren't the same, a 3" MAF housing still massively increases throttle response given the right software configuration.
#7
#9
#10
It was + 27% until I changed the IN/OUT setting to the Q45 MAF, 1 IN / 17 OUT = no correction.
This thread is cool:
http://forums.maxima.org/all-motor/3...iming-mod.html
This thread is cool:
http://forums.maxima.org/all-motor/3...iming-mod.html
#11
This is 3 inch here. Think it would be safe without a tune? and anybody ever use?
http://store.spectreperformance.com/...405/2231.0.1.1
They also allow you to build your own intake by piecing together the different bends and pipe then mark it and send it back to them for weld buff and polish.
Would make for a nice all in one unit I would say.
Thread
Thread Starter
Forum
Replies
Last Post