Aftermarket Radio Help
Aftermarket Radio Help
Hey guys,
Recently bought new JVC head unit for my 2003 SE non bose. I have every wire soldered and connected correctly, grounded the radio wire to the chassis, and have checked every fuse. Cannot get the unit to turn on and am running out of ideas. Any help would be greatly appreciated! Thanks!
Recently bought new JVC head unit for my 2003 SE non bose. I have every wire soldered and connected correctly, grounded the radio wire to the chassis, and have checked every fuse. Cannot get the unit to turn on and am running out of ideas. Any help would be greatly appreciated! Thanks!
Something is probably not connected correctly. Triple check all of your connections. Get a multi-meter and make sure you are getting voltage. Also check where you connected the ground to make sure it's good. Did you connect both the switched power and the constant?
If theirs no power at the radio harness I would check your fuses. Also check the fuses on the driver side under the hood. I know when I was wiring leds, I blew a fuse by accident and it cut off my radio and my cluster lights.
Fuse #1 in the top left corner of the fuse panel is for the radio power. Pull it out and check it with a meter or swap it. Sometime a fuse will look good to the eye.
In the nissan wire harness, check for voltage onthe purple wire in the connector that holds 12 wires. It is one of the corner wires, this is from the fuse. Don't forget to have the key in the ACC or ON position.
In the nissan wire harness, check for voltage onthe purple wire in the connector that holds 12 wires. It is one of the corner wires, this is from the fuse. Don't forget to have the key in the ACC or ON position.
Thread
Thread Starter
Forum
Replies
Last Post




