hi quick question
12-29-2012, 06:44 PM
#1
Newbie - Just Registered
Thread Starter
Join Date: Jul 2007
Posts: 8
hi quick question
hey guys im not really new here but never really posted anything before i just have a quick question i have a 01 max and i went to do my inspection today and it came up with cat monitors not ready i replaced my cats last year and also reset my ecu to ease the codes i had i dont have any cel on and there are no codes on my car any idea what this could be
12-29-2012, 06:53 PM
#2
Senior Member
Join Date: Dec 2008
Location: NYC
Posts: 1,799
Did you erase the codes immediately before your inspection? If so, there is your problem. You need to drive the car after clearing codes to get the monitors to start scanning again. Usually about 50-100 miles.
12-29-2012, 07:00 PM
#3
Newbie - Just Registered
Thread Starter
Join Date: Jul 2007
Posts: 8
tom i been driving the car for a year since my last inspection i never had to drive for that long the most i ever did was 100 miles to reset everything repairs was done last year around this time cus after i did my inspection last year my cel came on so i fixed it and reset my ecu
Thread
Thread Starter
Forum
Replies
Last Post
hez8813
5th Generation Maxima (2000-2003)
11
03-12-2020 12:06 AM
pears
5th Generation Maxima (2000-2003)
15
09-18-2015 05:25 AM