Need assistance! Engine swap. Can't find ground location. Picture inside...
#1
Senior Member
Thread Starter
iTrader: (3)
Join Date: Feb 2006
Location: Lewis Center, OH
Posts: 1,806
Need assistance! Engine swap. Can't find ground location. Picture inside...
Guys
I am done with all the wiring on my 6th gen to 5.5 gen swap, but one ground wire has me stumped. I cannot recall the proper location and am unable to find any bolt or rubbed surfaces that would give me any hint to where this is suppose to connect.
BLACK/YELLOW ground wire coming from the (-) battery and body ground location on driver side fender circled in red (as if you couldn't tell )...
Any help would be greatly appreciated!!!
I am done with all the wiring on my 6th gen to 5.5 gen swap, but one ground wire has me stumped. I cannot recall the proper location and am unable to find any bolt or rubbed surfaces that would give me any hint to where this is suppose to connect.
BLACK/YELLOW ground wire coming from the (-) battery and body ground location on driver side fender circled in red (as if you couldn't tell )...
Any help would be greatly appreciated!!!
#2
On my car, it's bolted to the top of the trans.
If you look down at the trans from the top left corner of the battery tray, it's a few inces to the left.
If you look down at the trans from the top left corner of the battery tray, it's a few inces to the left.
Last edited by Brl24; 09-15-2013 at 12:37 PM.
#3
Senior Member
Thread Starter
iTrader: (3)
Join Date: Feb 2006
Location: Lewis Center, OH
Posts: 1,806
THANK YOU! THANK YOU! THANK YOU!
Filling up all the fluids now.
Oil - DONE
Brake/Clutch Fluid - DONE
Transmission Gear Oil - TAKING FOREVER! ETA Unknown LOL
Radiator - Still needs done.
Steering - Still needs done.
Hoping to get started today!
Mechanically, all that needs done is connect clutch cables and y-pipe and that's it.
Filling up all the fluids now.
Oil - DONE
Brake/Clutch Fluid - DONE
Transmission Gear Oil - TAKING FOREVER! ETA Unknown LOL
Radiator - Still needs done.
Steering - Still needs done.
Hoping to get started today!
Mechanically, all that needs done is connect clutch cables and y-pipe and that's it.
Thread
Thread Starter
Forum
Replies
Last Post
BassAddictJ
7th Generation Maxima (2009-2015)
5
08-04-2015 11:38 AM
bassmann
4th Generation Maxima (1995-1999)
1
08-03-2015 07:53 PM