300ZX full "bbk"
#41
Any ideas on what exactly they'd have to mod or fabricate? I've already got the Y-Pipe back add on from CattMan.... hmm.... I wonder if Brian would be able to manufacturer me something if sent him the kit.
I'll ping him and let you all know what he says.
I'll ping him and let you all know what he says.
#42
I doubt Cattman will make a one off custom pipe to run Speedforce Setup, you need to ask your local shop..
Also this went way way way off topic
#45
Man... I really am tempted to spend the 3000 on the front 6POT and rear 4POTs tonight... "then the transformation will be complete!"
Well... not really, still need sway bar, strut bar, new performance shocks/struts, the intake manifold, throttle spacer..... damn, if there were only a bolt on Turbo or Supercharger available...
I'm gonna try taking pictures of her tomorrow.
Well... not really, still need sway bar, strut bar, new performance shocks/struts, the intake manifold, throttle spacer..... damn, if there were only a bolt on Turbo or Supercharger available...
I'm gonna try taking pictures of her tomorrow.
#46
That's cause you probably had less than 10 posts. Here in the org it works like that. The newbies must kiss the senior members a$$e$ for about 10 posts before they graduate. j/k man
#48
#49
If I was to be ballin' then I would have had my full WilWood BBK a while ago
Just stating that is a "low" price considered to the BBK that I've seen people putting on their Z's...one was close to $8,000... for fawkin' brakes!
I too am planning on the full 300ZX upgrade because I want to save money for better things...non-car related...just modding for the things that I find reasonable right now.
#52
Loaded = with pads
I have had the 300zx brakes for a couple years now and I am very pleased with them. They make a great low cost alternative to an aftermarket BBK and they are a Nissan product. I'd really love to have the rears fit.
I have had the 300zx brakes for a couple years now and I am very pleased with them. They make a great low cost alternative to an aftermarket BBK and they are a Nissan product. I'd really love to have the rears fit.
#53
#54
not many Altima guys are aware of this upgrade... I will do it and post it over there and see if i can create a buzz
#56
#63
but............................................... ................................
i am scoping out my350z.com.......
#66
03 (i do believe) non brembo 350z rear calipers and rotors bolt right up to 6th gen rears...
and since 3rd gen altimas have the same rears as 6th gens...................
see where i am going with this....
http://www.6thgenmaxima.org/forums/viewtopic.php?t=2247
#67
Thread
Thread Starter
Forum
Replies
Last Post
BPuff57
Advanced Suspension, Chassis, and Braking
33
04-16-2020 05:15 AM
mkaresh
8th Generation Maxima (2016-)
21
03-12-2018 06:48 PM