will the JDM NISSAN Z32 30MM aluminum calipers fit my
2004 Maxima SE they came off a 1996 300ZX (Z32 twin turbo).
any feed back would be greatly appreciated. im planning on doing
F and R do i also need any other harness to make it work..thanks

 

Join my6thgen.org and look here....

http://my6thgen.org/showthread.php?t=83&highlight=300zx

 

#1 , you CANT use the REAR

#2 , there is nothing JDM about z32 calipers

#3 , you will need the brackets , which I may have a set left for them to run 13inch rotors

 

thanks for the link bootz it very helpful..

 

do i only need the bracket if running the 13'' or
would i be fine with the oem rotor..thanks for the feed back

 

because the OEM 6th gen rotors are 12.6

you will need brackets to make them work.

even with the cobra brackets you can still run the 12.6 rotors, but you wouldnt be using the full face of the pad.

12.6 - 13inch rotors, so .4 of the pad you arent using.

 

thats much clearer now to what i had read.might be more costly
than i anticipated..might just have to wait..thanks though

 

not really, finding a used set of z32 calipers ranges from $100-$250 for the pair.

Brackets are $65 , decent HAWKs pads are about $50

using your 12.6 rotors, your still under $500

 

My kind of Thread, here are my pics of my set up, these are 13" rotors

 

thats actually not bad...where can i get the brackets..
do u happen to have a pair if u do i would buy those off u...
and would i have to replace the brake lines or is it plug and play for the most part....

 

damn that set up looks real good bro.congrats.....did u replace the brake lines..do u know if there are 13'' drilled only rotors available

 

Check PM