I just replace my alternator and my battery because the battery and brake light come out on my dashboard well at the end it was just the connection click that goes to the alternator so i replace it and its workig good now BUT THE LIGHTS ARE STILL ON ! ANY IDEAS HOW TO ERASE THAT?

 

I would use a scan tool, but if you cant you can do that.


How to reset ECU in 5th and 6th Generation Maxima’s

1. Turn ignition switch on and wait about 3 seconds.

Repeat the following steps (2a and 2b) procedures quickly five times within 5 seconds.

2a. Fully depress the accelerator pedal (HARD).
2b. Fully release the accelerator pedal.

3. Wait 7 seconds, fully depress the accelerator pedal and keep it for approx. 10 seconds until the CEL starts blinking. (here is where i think you can get a code from this.)
4. Fully release the accelerator pedal (while the CEL is still blinking)
5. Wait about 10 second.
6. Fully depress the accelerator pedal and keep it for more than 10 seconds.
7. Fully release the accelerator pedal (The CEL light will continue to blink).
8. Turn ignition switch to “OFF” position and now you can start the car. The CEL light should be gone.
Be Sociable, Share!

 

Did you verify that the alternator is indeed charging by measuring 13.4 - 14.5 volts at the battery, car running?