I had the bumper replaced due to it being hit, it is an aftermarket bumper because of money reasons but they didn't get the top of the bumper to meet the top of the car properly in the spot that i marked in the picture. it pops up higher on one side and noticeably does not look right, I can take it back to them but i know they will have it for a while again which i can't afford to do right now because of work. Anyone ever see this and have any ideas on how i can fix it. I tried modding the plastic connector that holds t there but no luck.



I can attach a pic of my actual car tomorrow and how it looks but figured I would at least get the post going

 

 

Other than trying a DIY, I would take it back to the installer and show them the issue and make an appointment when you can be off work for the time it takes to fix it. I would of never driven off the lot until it was to my satisfaction. If its not fixable in their eyes get another opinion or send the bumper back and get an OEM one.

 

at the lot it looked great, I guess from driving for a while it popped back out of place. i have to head over there this week and see what they can do