Good place to have Rods ...?
Thread Starter
Joined: Nov 2000
Posts: 3,323
From: amsterdam ,new york
Good place to have Rods ...?
Cryoed and shot peened ,i'am going to be doing this soon for a special build up for high rpm .
What place or places can you reccomend
thanks
What place or places can you reccomend
thanks
Thread Starter
Joined: Nov 2000
Posts: 3,323
From: amsterdam ,new york
Originally Posted by slammed95
Are you simply gonna use the stock pieces? I'd go with custom lightweight rods, designed for high-rpm N/A use.
Have you considered the RPM limits of the rest of the valvetrain, and drivetrain components? Most clutches are recommended under 8k. Pump cavitations? Chain tensioners?
Have you considered the RPM limits of the rest of the valvetrain, and drivetrain components? Most clutches are recommended under 8k. Pump cavitations? Chain tensioners?
As for high reving if i vq 35 with its feet per second more than the VQ 30 can with rods and pistons rev saftly to 8000RPM im sure i can go to 8500-9000 RPM
Thread Starter
Joined: Nov 2000
Posts: 3,323
From: amsterdam ,new york
Originally Posted by IceY2K1
What about rod bolts? Main studs? Do you plan to upgrade those?
I'd run a VQ35 oil pump. It should take more RPM, but I'm not sure about 8500rpm.
I'd run a VQ35 oil pump. It should take more RPM, but I'm not sure about 8500rpm.
Nobody has a idea of cryo and shot peen.
Thread
Thread Starter
Forum
Replies
Last Post
pkfinn
1st-3rd Generations Classifieds (1981-1994)
2
Jan 3, 2016 02:55 PM
95Maxi
4th Generation Classifieds (1995-1999)
7
Aug 29, 2015 09:38 PM
