SplitFire

Hey. I have a camaro, but my brother just got a '96 maxima. I'm designing one of the v-shaped boxes that I saw a picture of on here. I designed what I thought it should look like, and I was just wondering if this is close to what you have seen.

Picture 1

Picture 2
*Copy and Paste*

Anyway, thanks for any replies.

jmax

That's basically it. I can't remember what the ideal angle is for the drivers faceing each other. There is also a slope on the face. I can't remember the angle, but have it measured pretty close down in my garage. And you must leave enough room between the two drivers faceing each other so that the surrounds don't make contact beyond Xmax. Don't forget to measure how far above the basket the surround hangs out.

SWEETSOUND2001

iTrader: (30)

http://forums.maxima.org/showthread....hreadid=166268

jmax

Where have you been Anton? How's the Lex treating you? Have you seen what has been designed for your rear deck? http://www.acoustic-visions.com/tumult.htm

Should be able to eat 3 or 4 12" velodynes like a snack!

SWEETSOUND2001

iTrader: (30)

Haha..I wish...It simply won't clear my gas tank or my amp rack

SWEETSOUND2001

iTrader: (30)

victor

iTrader: (1)

very nice detail work. and that's one hell of a setup you have in your trunk. good stuff man.

jmax

It will work. You just need to work a little harder at getting it into the rear deck, instead f under the deck. Under the deck would definitely not work as you would need nearly two inches clearance above the woofer to allow for excursion. X-max is about 34mm, but I think it can go to about 45mm if pushed really hard.