where the hell can you run it? Also I got the back seat off as well as the door sills but can't figure out how to run the rca's down the side....in between the doors is the seat belt pillar can't figure out how to remove it? Any help would be greatly appreciated.

 

Run the RCA's down the middle. Remove the center console and rear seat. Just slide it down and through. The 0 gauge is not too difficult to get down the drivers side. If I remember correctly there are plastic panels that cover the factory wires. There should be enough room under this shroud for your 0 gauge. If not there is plenty of room outside of the shroud.

 

runt the power through the wheel well, after that, it should be simple ro run it under the stock plastic wire tube like jmax said. The seatbelt pillars pop off, they are held by clips. Just get in there with a screw driver and pull.

 

thanks very much guys.