and can it fit a 2 gauge wire?

 

hey I was looking for the same thing (trying to install my sub).

onecrazymaxnut did you find a good place?

 

If auto then drill where the clutch plate goes. If manual drill to the left bottom of the gas pedal. Both easily accesible and will fit a few 0Awg wires.

--Don

 

this tread should be a stickie

 

i still havent found it..but im sure there mustt be a gromet that alows wires to go in some where from the engin bay...ill look for it this wknd...

 

There really isnt one, but Ive only done about 90+ Maximas. Although some people take the long route and go through the fender somewhere. Rule of thumb, keep the distance of the wire shortest possible.

--Don

 

so don, where do you suggest to drill the hole?

also once its drilled what kind of grommet should i use or rather how should i seal the hole up?

 

Originally Posted by mzmtg
Remove the wheel well liner of the left-front wheel. You will see a very large grommet with a large wiring harness running into the passenger compartment. This is the pferfect place to run a wire into the car and along the left side of the car.


in the faqs

 

ok, I removed the tire and the plastic cover, and I found two holes, one mentioned on the tread above, and a smaller one where the hood cable goes, it is a bout 2 inches wide, perfect for any cable.
on the inside of the car I had a hard time.
I removed a ABS circuity box and all the insulation covers, then I ran my 4-gauge cable as deep as it could go on the carpeting, under the plastic cover of the seat belt, and under rear seat. (professional JOB)
It is very simple, just take your time.
thanks for all the help.