i do not know if this is a repost but if someone is unsure of what to do to fix the problem this is it.

i have heard from many ,that microscreen 7 inchers that are put into the dash are alittle uneven by a small amount. Well i installed my microvision screen yesterday, and that night my and my gilfriend were driving around and she kept *****in at me cause it was crooked( i did not notice it much). the way the screen sets on one side is higher than the other by just alittle bit. well since her nagging started i could not think of anythign eles today but that i need to take everything out and do it over again. well i did and i found an easy fix.



where the red square is ,there use to be metal there. this peice of metal was blocking that side of teh screen so it would not go up any further. i just took a saw to it cut that square off and set it where i wanted it. now it is perfectly starght and best of all i do not have to hear my girlfriends whining!