Things FOR SALE
Exhaust piping is silicone covered and wrapped
2.5 inch down-pipe into 3 inch after flex section
2.5 inch up-pipe
40mm waste made jgs precision
T04 T-61 with .68 exhaust and .70 compressor housing utilizing a P-trim turbine made by Master Power
V-band clamps
Turbo Support Bracket
Front Engine Mount

Everything is low low mileage meaning around 700 miles The kit was on a 3.5 maxima for about a week. This is for sale because another kit is in the making so there is nothing wrong with this one. However You will still need slim fans and vq30 headers (vq30 headers if you want to bolt it up to the vq35)
Basically all the hard work is already done to turbocharge your vq30 or vq35 maxima

Asking Price $2000 and would prefer to sell everything together.
contact me at (540) 746-0437 for serious inquires. If anything else send an email. NO PMS

Pics

 

Up-pipe


Turbo


Turbo Support Bracket-WasteGate with Dump Pipe


Everything together

 

any pic's of it installed?

what about the mount needs to be moded, like does it go over the mount or between the mount and rad support

also what changes are being made to the new piping

 

No pics of it installed but fitment is dead on. Ground clearance is still like stock because the up-pipes and the downpipe run parallel to the center beam and not under the transmission.

The Front Engine Mount is now included in the kit and it is pictured below
Also the new kit that is being made uses different headers (not vq30)

 

Original Post Edited...
Bump

 

will it clear a/c compressor?

or are you stuck with no a/c?