Just installed H&R springs on 2k2 got some Q's
#1
Just installed H&R springs on 2k2 got some Q's
i have a few noises in the front end and i'm wondering if they're just the springs settling or if the install wasn't right. Me and my friend did it ourselves.
the first noise is a "tink-tink-tink" sound; it's a very faint noise when i turn the steering wheel and can only be heard while the car is stationary. it may happen while the car is moving but i can't hear it. and rarely there's a "clank" sound that happens only when i fully turn the wheel.
any thoughts?
the first noise is a "tink-tink-tink" sound; it's a very faint noise when i turn the steering wheel and can only be heard while the car is stationary. it may happen while the car is moving but i can't hear it. and rarely there's a "clank" sound that happens only when i fully turn the wheel.
any thoughts?
#2
Member who somehow became The President of The SE-L Club
iTrader: (19)
Join Date: Jun 2001
Posts: 16,033
Did you position the upper strut perch with the word OUT facing out and in line with the lower strut mount?
Did you put the strut bearing in correctly?
Did you seat the springs evenly into the upper rubber seat?
Did you resuse the spring isolation sleves?
Did you put the strut bearing in correctly?
Did you seat the springs evenly into the upper rubber seat?
Did you resuse the spring isolation sleves?
#3
could be strut bushings problem >> http://forums.maxima.org/showthread.php?t=298085
even though it's on a 4th gen, it should be similar to 5th gen.
even though it's on a 4th gen, it should be similar to 5th gen.
Thread
Thread Starter
Forum
Replies
Last Post
MaxLife17
8th Generation Maxima (2016-)
43
06-27-2019 01:37 PM
Hdnseek
5th Generation Maxima (2000-2003)
3
09-09-2015 05:55 AM
lowpost99
1st & 2nd Generation Maxima (1981-1984 and 1985-1988)
1
09-08-2015 05:06 AM