Jane97SE

I finally got my BOV back from Stillen..4 months later(minus the spring they said they were changing)

Ok, how do I install a BOV? TIA

My 4DSC

(1) get the flange welded to the pipe that goes from the supercharger into your throttlebody...about halfway in between the two.
(2) bolt the BOV to the flange.
(3) hook up the vaccuum line.

Pretty simple, huh?

Chunger

iTrader: (1)

I assume that it was the same type that you had on there originally. Two bolts and the vacuum line. I could be wrong though.

Jane97SE

huh? I thought all I had to do was stick it on and tighten it.. uh-oh...

where would I get a vacuum line?

Thanks for your help

Chunger

iTrader: (1)

The one the comes with the SC kit or the HKS (IIRC) one?

Either way... they should both have a vacuum line that activates the BOV when you take your foot off the accelerator (creating a vacuum) behind the throttle body.

See bottom of page 6 on your SC instruction sheets

Jane97SE

It's a Blitz BOV..

I dunno.. I will try to put it back on tomorrow..I'll come back if I need any help..Thanks